FrameCover iPhone Case Installation Guide

FrameCover iPhone Case Installation Guide

To ensure the best performance and longevity of your FrameCover iPhone Case, follow these detailed steps for a flawless application:

Before You Begin: Ensure your workspace is clean and well-lit to avoid dust and dirt interference during the application process.

What You’ll Need:

  • Your FrameCover iPhone Case
  • Cleaning bag (included)
  • Patience for precision

Step-by-Step Installation:

1. Preparation

  • Begin by washing your hands to remove oils and dirt.
  • Dry your hands thoroughly with a lint-free towel.

2. Cleaning the iPhone

  • Open the cleaning bag provided with your FrameCover.
  • Use the wet wipe to thoroughly clean the back and sides of your iPhone. Focus on areas where the case will adhere, especially around the camera bump and edges.
  • Use the dry wipe to remove any streaks left by the wet wipe, ensuring a clean, dry surface.

3. Aligning the Case

  • Carefully remove the FrameCover from its packaging. Handle the case by the edges to avoid fingerprints on the adhesive areas.
  • Peel off the protective film from the adhesive strips on the FrameCover.

4. Application

  • Align the case with the camera and side buttons first. This is crucial as it determines the fit of the entire case.
  • Once aligned, gently place the case onto the back of the iPhone. Do not press down yet.

5. Securing the Case

 

  • Starting from the camera cutout, press down firmly to adhere the case to the phone. Smooth out any air bubbles toward the edges.
  • Press strong and hold at least for 30s.
  • Repeat the process with the lower section of the case, ensuring it is snug against the device.

6. Final Adjustments

 

  • Go around the edges with your fingers to ensure the case is fully secured on all sides.
  • If any edges lift, apply gentle but firm pressure until the adhesive takes hold.

After Installation:

  • Wait 30 minutes before placing the phone in pockets or using accessories to allow the adhesive to bond strongly.

Additional Tips:

  • If dust is caught under the case during application, use a piece of tape to remove it without touching the adhesive.
  • Avoid removing the case frequently, as this can weaken the adhesive.

Care and Maintenance:

  • To clean the case while it’s on your phone, use a soft, slightly damp cloth. Avoid getting moisture in any openings.

Troubleshooting:

  • If the case is not sticking properly, ensure that all surfaces are free from dust and oils. Repeat the cleaning process if necessary.
  • For persistent issues, contact our customer support for assistance.

By following these instructions, you'll ensure that your FrameCover iPhone Case is perfectly fitted to protect your iPhone while preserving its sleek appearance.